Related Articles:
    Arrow Making FAQ
    Arrows Fletching

Aluminium Arrows

    If you have not already had the arrow shafts cut to the correct length at the archery shop then you will need to use an arrow saw
Always check the arrow length before cutting. Its difficult to add length if you have cut them too short! Once the shafts are cut, carefully remove any burr from the inside of the shaft. Don't remove any of the shafts wall thickness though. Clean the rear end of the shafts where the fletches will be glued with 'Acetone' and at the same time, the shafts of the points can be cleaned to remove any loose oxide, oils or dirt.
A spare set of nocks can then be twisted onto the rear end of the shafts. Nocks, such as the Bjorn nock, will 'stick' to the shafts rear end by means of the roughened surface. It is recommended  a spare set of nocks is used, so that when they are placed into the fletching jig, I don't have to worry about the nocks opening up due to the jig's guides. The proper set of nocks can be glued on after the fletches are done.

    Before gluing the fletches, use 'Acetone' to clean the base of the fletches. Take care to align each fletch in the same place on the shaft. A guide mark can be placed on the fletching jig clamp for reference. Use super glue or a fletching glue on the fletches. Make sure the fletch rests evenly along its length onto the shaft when glued. This glue will set enough for the clamp to be removed after 3 minutes. If using a different coloured fletch for the 'Index Fletch', then its a good idea to glue these on first when using a multiple fletching jig, then glue the others on later. After the glue has set on the first fletch, rotate the nock holder to its next position, usually 120 degrees for a 3 fletch setup. Repeat until all fletches are on. You can apply extra glue to the front and rear of each fletch and this helps prevent  the fletch tearing off when the arrow lands in the ground or passes through a soft target. After removing the temporary nocks, the 'proper' nocks can be glued onto the rear of the arrow shafts. Apply a small amount of glue to the rear of the shaft, place the nock onto the shaft and then twist to evenly spread the glue. Take care to align the nock with the index fletch, then wipe off any excess glue. Allow the glue to set.

    To glue the points into the arrow shafts, use a hot melt glue. Melt some glue onto the point shaft, then apply heat to the point shaft until the glue starts to run. Slide the point into the arrow shaft using pliers to hold the point as it will be too hot to hold, twisting it to evenly spread the glue. Make sure the point is in all the way before the glue cools and starts to set. Hold the point in place until the glue sets.

Don't apply too much heat to the arrow shaft, as excessive heat can make the aluminium brittle. To remove points, carefully apply heat to the point and arrow shaft, just enough to melt the glue, then use pliers to pull the point out.

Carbon Arrows

    The process to make up a set of carbon arrows is much the same as for aluminium arrows except that the arrow shafts should only be cleaned with an abrasive cleaner, rinsed and let dry.

Never apply heat to a carbon arrow shaft to remove the points, apply heat to the point only until the glue melts.

For more information on making arrows please see the list of related articles